Does anyone happen to have, or know where I could obtain either a clutch master cylinder, or rebuild kit / seals for one, for a 1975 RH11 HiAce (part #31410)?

I've not been able to find either. Have been in touch with a company about rebuilding it, but they said they would need to obtain new seals. I'm hoping for the best but realistically not expecting them to find them.

I have a master cylinder for the later (1977 on) RH11 but the mounting hole spacing is different, and it looks quite a bit different so wouldn't expect the seals to be the same (although I could take both apart and check).

If all else fails, is there anywhere that supplies seals by size that may fit? Or even make custom size seals?

Any help much appreciated!

Looking for a recommended service centre to look at the LPG section of the engine, it seems to be running sllw on tick over, where it will cut out if i stop at lights, runs fine on the motorway on LPG 

Any advice would he great, 

Richard 

looking for some advice on how to remove the rear seating in the above model.

i have removed the small single seat near the sliding door, but cannot  remove the floor runner

Is there an easy way to remove the floor runner or is it complete runner rip out, i would like to leave the track in place if possible. 
 

any help would be appreciated 

Thanks

I'm looking for a brake booster/servo unit for my Hiace Commuter LH71 (2.4L diesel). Having trouble finding this part so I thought id ask the fine folks on this forum. Ive searched eBay and online part stores. Ive almost always found parts this way, its not usually much of a problem to get them, but this brake servo seems a little trickier.

Can anyone recommend where I might look?

Im in Australia btw.

Altenator is new, voltage at Battery is 12+ when off and 14.4 when running. ECU was swapped and no change. Replaced 2 relays (spill valve and diesel main engine) and no change. Starter was rebuilt a year ago and no issues since, again it won't even click likes electricity is getting to the starter.

Any ideas on where to start?

Been advised that our rear springs need replacing at some point on our 2002 Hiace Devon campervan (Diesel), but the garage can't find the right parts. Anyone know what size they should be and recommend a supplier?

 Thanks in advance if anyone can help .

First post here. I have a 2008 150k 2.5l d4d Hiace. UK spec.

It has what I can only describe as a ticking noise that comes at 1500-2000rpm under no load. Seems to be to be around the passenger side of the engine (that's as you look in the engine bay off to the right hand side. Just sounds bad. Fine at idle, and I can't hear anything around 2500rpm. 

Not sure where to start, it's not a belt or pulley, it's not the turbo by the looks of where the noise is originating.

Any help would be much appreciated. Thanks,

Adam

I have recently replaced all 4 injectors, fuel filter, engine oil + filter and timing belt. car starts and runs as normal, but there is very low power.

No smoke, no dtc, nothing.

Any clues what the problem could be?

Timing belt is right, injector is showing close to 0 on feedback values

Just bought a 1998 Hiace (LWB, Petrol).

The fan and air conditioning seems to be working fine, the side vents are blowing strong and cold. The center vents, however, aren’t blowing at all. 
 

I thought at first maybe the vent selector wasn’t working properly, and even when it’s set on regular fan at your face, there is a bit of air coming through the demister vents on the windscreen. But then when I flick the switch to demister vent, it gets a lot stronger… so now I’m thinking that probably isn’t the issue.
 

Has anyone else had this issue?  I’d be very grateful for any knowledge or advice you have to share! 

Thanks 

I'm emigrating to Australia in August. I have a 92 Hiace Super GL camper conversion that began life in Japan. It’s currently in the UK.

I know there are plenty of these vans around in Australia, but selling my van in the UK could prove difficult. Even though there are lots of costs and hassles involved with importing, I might still be better off bringing the van with me … if I can get it through all the various stages. 

Has anyone tried to do this lately (from anywhere - not just the UK)? I keep reading about Australia’s asbestos tests for imports. Wondered if anyone had fallen foul of this? 

Thanks in advance.

Al

I am looking for a layout for the interior fuse box for the above, I have lost my automatic dashboard gear selector light and Digital Odometer, want to try and find the fuse.

Thanks

Well, it’s been some months now and having joined various forums and exhaustive internet searches, still haven’t sourced this Front Left ABS Sensor (part no: 89543-26130). I sent out three letters to Toyota HQ Japan without a response, and around thirty-five emails to breaker’s yards, eBay and ABS specialists worldwide, plus three orders from Japan processed but cancelled as they then couldn’t get the part.
The best chance I have now is having found a breaker selling parts for another HiAce, but as there’s no guarantee it will fit and with a hefty refund penalty, I’m hoping we have some Wiz Mechanics or Toyota Masters who can answer my queries below please:

• Will an ABS or even the entire wheel drum from this 2002 Toyota Grand Hiace/Granvia 3.4 V6 Auto 8 Seater MPV fit my model (below left), which is two years newer/registered 2004?
• If not, what other models and years of HiAce should I be looking for as a used wheel drum complete or ABS from the breaker yards, please?
• Any other suggestions regards fixes or get-arounds would be Most Welcome? Thank You

Spare Parts: Reg 2002                                    My Vehicle: Reg 2004 below/cdn-cgi/image/format=auto,onerror=redirect,width=1920,height=1920,fit=scale-down/https://www.toyotanation.com/attachments/1685950926883-png.423885/

Many Thanks

I have a 2013 KDH206V Hiace without a passenger airbag, and I was wondering if it was possible to fit one. There's a compartment where the airbag would be if fitted. Would fitting one involve simply adding the airbag to this slot? Maybe a per-tensioner for the seat belt too? Or is the wiring and ECU different for models with twin-airbags. I'd only get Toyota or an authorized auto mechanic to fit the airbag, just wondering if this is possible before selling my van.

Thanks!

Thanks, Charlie